Reply to thread

Message: <blockquote data-quote="n2audio" data-source="post: 4090155" data-attributes="member: 540940">you don't have to use both speaker terminals on the amp - not all mono's have two anyway.If you do use them both -- they are parallel inside the amp.  That means you can wire each sub's coils in parallel resulting in 2 ohms and connect each sub to its own terminal on the amp which would give you the 1 ohm final load.Alternatively you can just connect all the (-)'s and all the (+)'s and only run one +/- to the amp.Yes, the amp needs to equal the total rms of the subs.  Ex., for a couple Type R's at 500w rms each you'd want an amp around 1000w rms at 1 ohm.  Power doesn't have to be exact.</blockquote>

Top