Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Wire and electrical set up?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="DaveDSMer" data-source="post: 2341447" data-attributes="member: 571598"><p>Ok its almost time to tear apart this car (Lincoln Mark VIII) and install all these new parts so its wire buying time. I am running a single amp (Eclipse XA5000) with 75watts @ 2ohm to front and rear speaker sets and right now running the sub channel @ 4ohm so about 300 watts but may set it up later for 2ohm @ 450watts. No caps. So you are looking at a total of 750rms wattage at full tilt. Now I know the eclipse amps are pretty efficient and this one is using class D circuitry so thats a plus. I plan on running 14ga wires to the front and rear speakers. 12ga wires for the sub channel. 4ga wire from the battery to the amp. Right now its got a 120amp alternator and I need to get a new battery.. may just go grab a Duralast Gold up at autozone or something. So is this wire set up ok for this power range? No I am not going to be upgrading this car anymore than that as far as audio goes. If i want bigger and louder it will be on the next car I get.</p></blockquote><p></p>
[QUOTE="DaveDSMer, post: 2341447, member: 571598"] Ok its almost time to tear apart this car (Lincoln Mark VIII) and install all these new parts so its wire buying time. I am running a single amp (Eclipse XA5000) with 75watts @ 2ohm to front and rear speaker sets and right now running the sub channel @ 4ohm so about 300 watts but may set it up later for 2ohm @ 450watts. No caps. So you are looking at a total of 750rms wattage at full tilt. Now I know the eclipse amps are pretty efficient and this one is using class D circuitry so thats a plus. I plan on running 14ga wires to the front and rear speakers. 12ga wires for the sub channel. 4ga wire from the battery to the amp. Right now its got a 120amp alternator and I need to get a new battery.. may just go grab a Duralast Gold up at autozone or something. So is this wire set up ok for this power range? No I am not going to be upgrading this car anymore than that as far as audio goes. If i want bigger and louder it will be on the next car I get. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Wire and electrical set up?
Top
Menu
What's new
Forum list