Reply to thread

Message

<blockquote data-quote="Bun-Bun" data-source="post: 4732681" data-attributes="member: 584852">Ok so I just measure down the middle and make that dimension the same as the number that comes out of WinISD? What do I do with the endcorrection box? it gives me those 3 options I listed earlier and when I change values then a value goes into that box.And here <a href="http:////forum/showthread.php?t=218918&amp;amp;highlight=bent+port+length" target="_blank">http://www.caraudio.com/forum/showthread.php?t=218918&amp;amp;highlight=bent+port+length</a> they are talking about end correction being used whenever a side of the enclosure acts as part of the port... which makes sense and I understand tane 1/2 width of port and subtracting it from the port length to get my physical length but the end correction box in WinISD makes me think it already does this and that I should just select the 1 side flanged option and build to that...I dont know...</blockquote>

[QUOTE="Bun-Bun, post: 4732681, member: 584852"] Ok so I just measure down the middle and make that dimension the same as the number that comes out of WinISD? What do I do with the endcorrection box? it gives me those 3 options I listed earlier and when I change values then a value goes into that box. And here [URL="http:////forum/showthread.php?t=218918&highlight=bent+port+length"]http://www.caraudio.com/forum/showthread.php?t=218918&highlight=bent+port+length[/URL] they are talking about end correction being used whenever a side of the enclosure acts as part of the port... which makes sense and I understand tane 1/2 width of port and subtracting it from the port length to get my physical length but the end correction box in WinISD makes me think it already does this and that I should just select the 1 side flanged option and build to that... I dont know... [/QUOTE]

Verification