Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Will this setup be good?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="!.beat killer.!" data-source="post: 6922148" data-attributes="member: 624518"><p>I have a ported box that is 3 ft long, 17 inches deep, and 13 inches wide. The subs i am planning on using are the soundstream Arachnids that are 12" and 4ohm with 250 rms. the model # is (sw-12se). the amp i think i am going to use is the soundstream picasso 2 channel which has 180 watts x 2 channel on 4 ohms and on 2 ohms it is 270 watts x 2 channels. The amp is a 540 watt rms total. The model # for the amp is (pcx2.540) I am going to use 4 gauge power wire and ground wire for the amp. I dont want nothing extremely loud but i want something that hits good. My trunk in my car gets no air through it unless i open the trunk. my seats dont go down so the subs dont get much air. I was just wondering if this would be a good setup for me. Ive been doing some research and so far i like this setup.. i dont want to put to much money in the system.</p></blockquote><p></p>
[QUOTE="!.beat killer.!, post: 6922148, member: 624518"] I have a ported box that is 3 ft long, 17 inches deep, and 13 inches wide. The subs i am planning on using are the soundstream Arachnids that are 12" and 4ohm with 250 rms. the model # is (sw-12se). the amp i think i am going to use is the soundstream picasso 2 channel which has 180 watts x 2 channel on 4 ohms and on 2 ohms it is 270 watts x 2 channels. The amp is a 540 watt rms total. The model # for the amp is (pcx2.540) I am going to use 4 gauge power wire and ground wire for the amp. I dont want nothing extremely loud but i want something that hits good. My trunk in my car gets no air through it unless i open the trunk. my seats dont go down so the subs dont get much air. I was just wondering if this would be a good setup for me. Ive been doing some research and so far i like this setup.. i dont want to put to much money in the system. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Will this setup be good?
Top
Menu
What's new
Forum list