Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Which preouts to use?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="baker440ex" data-source="post: 8699248" data-attributes="member: 679167"><p>Ok that's a little above my head. I have wired a handful of similar systems as a kid but never anything serious. Usually just played with settings until it sounded the way I liked. Will it hurt anything to run it off the rear output. The sub is a dual voice coil and I have the two terminals briged inside the box w a jumper wire and then outside the box I have the two channels of the amp bridged. All my amp settings are in the center. I do have an X-OVER button which can be set to LPF, FULL or HPF</p><p>I do have a multimeter but not really familar with it. Usually stick with the circuit tester.</p></blockquote><p></p>
[QUOTE="baker440ex, post: 8699248, member: 679167"] Ok that's a little above my head. I have wired a handful of similar systems as a kid but never anything serious. Usually just played with settings until it sounded the way I liked. Will it hurt anything to run it off the rear output. The sub is a dual voice coil and I have the two terminals briged inside the box w a jumper wire and then outside the box I have the two channels of the amp bridged. All my amp settings are in the center. I do have an X-OVER button which can be set to LPF, FULL or HPF I do have a multimeter but not really familar with it. Usually stick with the circuit tester. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Which preouts to use?
Top
Menu
What's new
Forum list
