Reply to thread

Message

<blockquote data-quote="powerstroker" data-source="post: 6176514" data-attributes="member: 611999">Ok, so it looks like I may have to send my amp off to get repaired. It is a Crossfire XP600D, and I am getting no output from it. I have the blue &quot;good power&quot; led, but no sounds. I am running 4 awg Knu Flex and have a good ground (frame rail, less than 15&#039;&#039; ground cable). I have checked the rca&#039;s and remote wire (neither are pinched, cut, etc.), and my HU settings are correct.I really wanna get some music playing, and am thinking about buying a used amp from here to run my 4 new Sundown E8&#039;s @1 ohm. I have seen a couple of amps on here that were relatively cheap. (Hifonics 750W mono amp, Fusion 100W mono). Should I wait it out and get the Crossfire fixed? Or should I get it fixed and buy one of these to get me by and then sell both of them and buy a Sundown SAE1200D?Thanks for any replies, and possible suggestions for getting my Crossfire working.EDIT: May be a REALLY DUMB QUESTION, but could the fact that I don&#039;t have a remote gain knob be the problem, ie; gain is turned all the way down, and I have no way to turn it up? Or should the gain control on the amp override it when I turn it up on the amp?</blockquote>

[QUOTE="powerstroker, post: 6176514, member: 611999"] Ok, so it looks like I may have to send my amp off to get repaired. It is a Crossfire XP600D, and I am getting no output from it. I have the blue "good power" led, but no sounds. I am running 4 awg Knu Flex and have a good ground (frame rail, less than 15'' ground cable). I have checked the rca's and remote wire (neither are pinched, cut, etc.), and my HU settings are correct. I really wanna get some music playing, and am thinking about buying a used amp from here to run my 4 new Sundown E8's @1 ohm. I have seen a couple of amps on here that were relatively cheap. (Hifonics 750W mono amp, Fusion 100W mono). Should I wait it out and get the Crossfire fixed? Or should I get it fixed and buy one of these to get me by and then sell both of them and buy a Sundown SAE1200D? Thanks for any replies, and possible suggestions for getting my Crossfire working. EDIT: May be a REALLY DUMB QUESTION, but could the fact that I don't have a remote gain knob be the problem, ie; gain is turned all the way down, and I have no way to turn it up? Or should the gain control on the amp override it when I turn it up on the amp? [/QUOTE]

Verification