Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
What cha think??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Omarvelous" data-source="post: 1233103" data-attributes="member: 551770"><p>there was a REALLL good writeup i think on this site A WHILE back that showed it.</p><p></p><p>Make slits in a sheet of wood like so</p><p></p><p>| | | | | | | | | deep enough but not alll the way through, and it will flex slightly. The deeper the slit, the more the flex, but the more the chance of fing up the flex.</p><p></p><p>I think it might have been Ramos that did this...not sure, was lonnng ago.</p><p></p><p>But honestly, i'm thnking bout doing the bottom MDF, and the Top Fiberglass, but glassing the inside, to cut down on the needed sanding/preping to the outside that would b needed if doing it from the top.</p></blockquote><p></p>
[QUOTE="Omarvelous, post: 1233103, member: 551770"] there was a REALLL good writeup i think on this site A WHILE back that showed it. Make slits in a sheet of wood like so | | | | | | | | | deep enough but not alll the way through, and it will flex slightly. The deeper the slit, the more the flex, but the more the chance of fing up the flex. I think it might have been Ramos that did this...not sure, was lonnng ago. But honestly, i'm thnking bout doing the bottom MDF, and the Top Fiberglass, but glassing the inside, to cut down on the needed sanding/preping to the outside that would b needed if doing it from the top. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
What cha think??
Top
Menu
What's new
Forum list
