Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
What are gains?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Rukuzz" data-source="post: 22659" data-attributes="member: 542128"><p>I setup my 2 -8ohm JL 10wOs to my sony xplod 2150gsx 760w (380w x1 bridged). I put the hu to 3/4 and then turned up the gain till distorted then down a little less than half way.</p><p></p><p>I noticed that one of the speakers sounds like it's being tapped by a nail on the dust cap.</p><p></p><p>I thought I was clipping so I went down just a bit more on the gain and it stopped. The wierd thing is that the other speaker wasn't doing that.</p><p></p><p>My hu is a factory one and has no numbers to make sure where i'm at. I got it to sound clean and then I setup the speakers.</p><p></p><p>I think that i'm riding the volume because I turn it down a notch and the taping goes away.</p><p></p><p>Anyway should both these speakers need 250w rms combined. If i have them wired in parallel and brided isn't that 190w running both speakers. Can anyone explain any of this?</p><p></p><p>thanks</p></blockquote><p></p>
[QUOTE="Rukuzz, post: 22659, member: 542128"] I setup my 2 -8ohm JL 10wOs to my sony xplod 2150gsx 760w (380w x1 bridged). I put the hu to 3/4 and then turned up the gain till distorted then down a little less than half way. I noticed that one of the speakers sounds like it's being tapped by a nail on the dust cap. I thought I was clipping so I went down just a bit more on the gain and it stopped. The wierd thing is that the other speaker wasn't doing that. My hu is a factory one and has no numbers to make sure where i'm at. I got it to sound clean and then I setup the speakers. I think that i'm riding the volume because I turn it down a notch and the taping goes away. Anyway should both these speakers need 250w rms combined. If i have them wired in parallel and brided isn't that 190w running both speakers. Can anyone explain any of this? thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
What are gains?
Top
Menu
Home
Refresh