Reply to thread

Message

<blockquote data-quote="BloodyDischarge" data-source="post: 1179748" data-attributes="member: 563682">I&#039;m lookin at 2 Alpine Type-X subs.&nbsp; I don&#039;t know too much so I would appreciate your opinions.&nbsp; Here are the speaker stats:12&quot; subwoofer with dual 4-ohm voice coilscarbon fiber/aluminum honeycomb cone with high-roll Santoprene rubber surroundcast aluminum framefrequency response: 23-200 Hzpower range: 500-1,000 watts RMS (500 watts per coil)peak power handling: 3,000 wattssensitivity: 83 dBNow I know nothing about amps (meaing channels, ohms. and such).&nbsp; I&#039;m currently looking at&nbsp; the MA Audio HK4000D but don&#039;t know if this will be a mistake or not.&nbsp; I wan&#039;t to be able to power these subs fully.&nbsp; Here are the stats for that amp:4000W Digital Class X Competition mono block amplifier1800W x 1 at 4 ohm (14.4V)3600W x 1 at 2 ohm (14.4V)2000W x 1 at 4 ohm (17V)4000W x 1 at 2 ohm (17V)Temperature, voltage, output level LCD displayThermal/short/overload protection circuitryPlatinum-plated screw type RCA jacksDouble-sided black epoxy PCB boardPlatinum-plated block terminalsFully unregulated power supplyStainless steel finish heat sinkQuiet fan cooling systemRemote gain controlFull MOSFET circuitry10-350Hz frequency responseVariable 0-18dB bass boost control at 45HzAmp preamp outputsBuilt-in crossoverThank you for reading</blockquote>

[QUOTE="BloodyDischarge, post: 1179748, member: 563682"] I'm lookin at 2 Alpine Type-X subs. I don't know too much so I would appreciate your opinions. Here are the speaker stats: 12" subwoofer with dual 4-ohm voice coils carbon fiber/aluminum honeycomb cone with high-roll Santoprene rubber surround cast aluminum frame frequency response: 23-200 Hz power range: 500-1,000 watts RMS (500 watts per coil) peak power handling: 3,000 watts sensitivity: 83 dB Now I know nothing about amps (meaing channels, ohms. and such). I'm currently looking at the MA Audio HK4000D but don't know if this will be a mistake or not. I wan't to be able to power these subs fully. Here are the stats for that amp: 4000W Digital Class X Competition mono block amplifier 1800W x 1 at 4 ohm (14.4V) 3600W x 1 at 2 ohm (14.4V) 2000W x 1 at 4 ohm (17V) 4000W x 1 at 2 ohm (17V) Temperature, voltage, output level LCD display Thermal/short/overload protection circuitry Platinum-plated screw type RCA jacks Double-sided black epoxy PCB board Platinum-plated block terminals Fully unregulated power supply Stainless steel finish heat sink Quiet fan cooling system Remote gain control Full MOSFET circuitry 10-350Hz frequency response Variable 0-18dB bass boost control at 45Hz Amp preamp outputs Built-in crossover Thank you for reading [/QUOTE]

Verification