Reply to thread

Message: <blockquote data-quote="goingdef" data-source="post: 6888049" data-attributes="member: 584989"><p>If your going to push on it even pressure all the way around if it goes in/out with no rubbing it's fine any speaker will make that noise if you apply pressure to one side of the cone( it's only held center by the cloth spiders and rubber/foam surround) what you will end up doing if you continue to do that is rub/wear the epoxy off the voice coil wire (which is nothing more then an electro magnet)once there is a spot where electricity can make contact on the vc(no more epoxy) the speaker is ruined and will most likely burn on that spot or heat up the solder on the tinsels causing them to come undone.</p></blockquote><p></p>

Top