Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Wall Box Design
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="iamamp3pimp" data-source="post: 3249031" data-attributes="member: 550386"><p>i like port bottom, you can feel it a whole lot more.</p><p></p><p>im not suggesting that you do any cutting....check the dancefloor that i put in.</p><p></p><p>you need some 1/2 or 5/8 bolts, and fender washers on each side</p><p></p><p>measure from the sides......where you think that the sides of the box will be.</p><p></p><p>if you measured from the middle, once you get the back, and other shit on, the top and all that wont fit, because the middle has a bow, and the sides probably wont evenm go on right.</p><p></p><p>i elarned that the hard way</p><p></p><p>twice...</p></blockquote><p></p>
[QUOTE="iamamp3pimp, post: 3249031, member: 550386"] i like port bottom, you can feel it a whole lot more. im not suggesting that you do any cutting....check the dancefloor that i put in. you need some 1/2 or 5/8 bolts, and fender washers on each side measure from the sides......where you think that the sides of the box will be. if you measured from the middle, once you get the back, and other shit on, the top and all that wont fit, because the middle has a bow, and the sides probably wont evenm go on right. i elarned that the hard way twice... [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Wall Box Design
Top
Menu
What's new
Forum list
