Reply to thread

Message

<blockquote data-quote="Bradleyc2" data-source="post: 6528361" data-attributes="member: 617145">I would think that is the problem. Always make and secure a soild ground. //content.invisioncic.com/y282845/emoticons/crazy.gif.c13912c32de98515d3142759a824dae7.gifGenerally, if you are looking to measure resistance you would stick the probe in the front/beginning of the wire and probe at the end/harness of the wire for resistance. The least amount the better when measuring resistance in wires.Example: Your ground..Measure resistance beginning at the harness plug (black wire) to where you have the ground wire bolted down. If you measure 0 resistance then your good, but if you notice no change in the reading then your open and need to make the correction.To test your ground:Find a constant 12v source and plug the red end of your DMM into it measuring DC Voltage.. DC Voltage, not AC. Then stick the black end of your DMM to where you bolted your ground and see if you measure 12v on that end.. if not, there is your problem.Let us know how this turns out and keep us posted</blockquote>

[QUOTE="Bradleyc2, post: 6528361, member: 617145"] I would think that is the problem. Always make and secure a soild ground. [IMG]//content.invisioncic.com/y282845/emoticons/crazy.gif.c13912c32de98515d3142759a824dae7.gif[/IMG] Generally, if you are looking to measure resistance you would stick the probe in the front/beginning of the wire and probe at the end/harness of the wire for resistance. The least amount the better when measuring resistance in wires. Example: Your ground.. Measure resistance beginning at the harness plug (black wire) to where you have the ground wire bolted down. If you measure 0 resistance then your good, but if you notice no change in the reading then your open and need to make the correction. To test your ground: Find a constant 12v source and plug the red end of your DMM into it measuring DC Voltage.. DC Voltage, not AC. Then stick the black end of your DMM to where you bolted your ground and see if you measure 12v on that end.. if not, there is your problem. Let us know how this turns out and keep us posted [/QUOTE]

Verification