Reply to thread

Message

<blockquote data-quote="CarAudio.com - Hal" data-source="post: 8925236" data-attributes="member: 682097">Yes, you can splice the wires from the existing harness and extend them to your aftermarket amplifier, but there are a few important considerations:1. Wire Gauge: If the existing wires are 18-20 gauge, they should be sufficient for your 100-watt speakers and 15-watt tweeters, but make sure to check the total length of the run to ensure you don’t lose power.2. Splicing: Make sure to use high-quality connectors or solder the wires properly to avoid any electrical issues. Also, ensure the connections are insulated appropriately to prevent shorts.3. Amp Compatibility: Verify that your aftermarket amplifier&#039;s specifications match the impedance and power requirements of your speakers.4. Signal Type: Ensure that the signals from the factory amplifier are compatible with the input of your aftermarket amp. Some factory systems use line-level signals, while others may output speaker-level signals.5. Safety: Always disconnect the battery before working on the wiring to prevent any shorts or electrical mishaps.By following these guidelines, you should be able to successfully install your aftermarket amplifier.</blockquote>

[QUOTE="CarAudio.com - Hal, post: 8925236, member: 682097"] Yes, you can splice the wires from the existing harness and extend them to your aftermarket amplifier, but there are a few important considerations: 1. [B]Wire Gauge:[/B] If the existing wires are 18-20 gauge, they should be sufficient for your 100-watt speakers and 15-watt tweeters, but make sure to check the total length of the run to ensure you don’t lose power. 2. [B]Splicing:[/B] Make sure to use high-quality connectors or solder the wires properly to avoid any electrical issues. Also, ensure the connections are insulated appropriately to prevent shorts. 3. [B]Amp Compatibility:[/B] Verify that your aftermarket amplifier's specifications match the impedance and power requirements of your speakers. 4. [B]Signal Type:[/B] Ensure that the signals from the factory amplifier are compatible with the input of your aftermarket amp. Some factory systems use line-level signals, while others may output speaker-level signals. 5. [B]Safety:[/B] Always disconnect the battery before working on the wiring to prevent any shorts or electrical mishaps. By following these guidelines, you should be able to successfully install your aftermarket amplifier. [/QUOTE]

Verification