Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Upgrading my budget system [Help Wanted] 6/29/2016
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Jeffdachef" data-source="post: 8512225" data-attributes="member: 650438"><p>Having the crossovers in the trunk for looks is nice, however i have underneath my dash and glove compartment since im cheap with wire since i use 12 gauge ofc and that stuffs expensive. You just have a positive and negative run from the amp to the input pos and negative of the crossover. Not that hard just pos to pos,neg to neg.</p><p></p><p>With the tweeters, dont fully install them, have them playing and put double sided tape to each location and see which locations sound best then mount it at that location.</p><p></p><p>Your alpine amp and most other amps on the market will work fine with that set we already know the ohm load before we even recommended to you bud.</p><p></p><p>Wire channel 1 and two pos and negative to crossover input pos and negative</p><p></p><p>Then wire rears straight to channels 3 and 4. Its very simple bud.</p></blockquote><p></p>
[QUOTE="Jeffdachef, post: 8512225, member: 650438"] Having the crossovers in the trunk for looks is nice, however i have underneath my dash and glove compartment since im cheap with wire since i use 12 gauge ofc and that stuffs expensive. You just have a positive and negative run from the amp to the input pos and negative of the crossover. Not that hard just pos to pos,neg to neg. With the tweeters, dont fully install them, have them playing and put double sided tape to each location and see which locations sound best then mount it at that location. Your alpine amp and most other amps on the market will work fine with that set we already know the ohm load before we even recommended to you bud. Wire channel 1 and two pos and negative to crossover input pos and negative Then wire rears straight to channels 3 and 4. Its very simple bud. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Upgrading my budget system [Help Wanted] 6/29/2016
Top
Menu
Home
Refresh