Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Unique situation..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="solidcrowd" data-source="post: 8145477" data-attributes="member: 565671"><p>My amp grounds are great. I believe they are the rear struts. I don't believe I grounded my headunit correct after doing research. I just ran the ground to the black wire (ground) on the wire harness. So it's being grounded that way...should I leave it like that and run a ground wire / splice it with those two?</p><p></p><p>This problem has been over shadowed by my subwoofer cutting out now though. I recently played a muggy song that I believe was enhanced and blew a few fuses on my Alpine pdx1.1000 amp and after that smoke was pouring out of the port. So I replaced the fuses, amp turns on fine. Tested the subwoofer briefly upstairs on my plate amp. Put it back in and now when I give it a decent amount of volume it cuts out...butt will start playing again after I turn the headunit off and back on. Any ideas on my two problems now lol?</p></blockquote><p></p>
[QUOTE="solidcrowd, post: 8145477, member: 565671"] My amp grounds are great. I believe they are the rear struts. I don't believe I grounded my headunit correct after doing research. I just ran the ground to the black wire (ground) on the wire harness. So it's being grounded that way...should I leave it like that and run a ground wire / splice it with those two? This problem has been over shadowed by my subwoofer cutting out now though. I recently played a muggy song that I believe was enhanced and blew a few fuses on my Alpine pdx1.1000 amp and after that smoke was pouring out of the port. So I replaced the fuses, amp turns on fine. Tested the subwoofer briefly upstairs on my plate amp. Put it back in and now when I give it a decent amount of volume it cuts out...butt will start playing again after I turn the headunit off and back on. Any ideas on my two problems now lol? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Unique situation..
Top
Menu
Home
Refresh