Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Understanding OHMs
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="budgetSQ" data-source="post: 25678" data-attributes="member: 541814"><p>OK... *cracks knuckles*</p><p></p><p>assuming that your amp is stable to 3 ohms (most are) the easiest way to do this is to wire each channel from amp in parallel to 1 sub. That would be Pos. to both pos, Neg. to both neg. This would give u a 3 ohm load.</p><p></p><p>If your amp was 500x2 @ 4 ohms, this would give you about 750 watts to each sub</p><p></p><p>If you had a mono amp, you could wire it down to 1.5 ohms by wiring all 4 vcs in parallel. Pos to 4 pos, Neg. to 4 neg.</p><p></p><p>If it was a 1000x1 @ 4 ohms amp, this would give you around 1500 to each sub</p><p></p><p>these number are just guesses... depends on your amp //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif</p></blockquote><p></p>
[QUOTE="budgetSQ, post: 25678, member: 541814"] OK... *cracks knuckles* assuming that your amp is stable to 3 ohms (most are) the easiest way to do this is to wire each channel from amp in parallel to 1 sub. That would be Pos. to both pos, Neg. to both neg. This would give u a 3 ohm load. If your amp was 500x2 @ 4 ohms, this would give you about 750 watts to each sub If you had a mono amp, you could wire it down to 1.5 ohms by wiring all 4 vcs in parallel. Pos to 4 pos, Neg. to 4 neg. If it was a 1000x1 @ 4 ohms amp, this would give you around 1500 to each sub these number are just guesses... depends on your amp [IMG]//content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif[/IMG] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Understanding OHMs
Top
Menu
What's new
Forum list
