Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Twin Sundown SA6.5 SW D2 32Hz Ported 0.6ft3 in Ford Escape Box Build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="imsickofweed" data-source="post: 8646955" data-attributes="member: 668971"><p>Subs are D2 series parallel for 2ohm load at amp, my amp is not 1ohm stable. I set gains with my Fluke DMM at 30VAC with flat EQ, 0 bass boost and bas knob at 1/2 way. Subs are rated at 200wrms so Im not quite to 500wrms, but Im plenty more than 400wrms. Id say Im around 9/10 on the gain pot. I adjusted the bass boost to get a little more boomy rumble on some songs and now I like it on most songs. I turn it down on more of the mild bass/trance tracks, but it stays at 2-3 90% of the time. I have my low pass sub filter on the HU at 80Hz, but set it to 85 on the amp. Im guessing I should just set them the same or maybe go full range on the amp crossover and just set it with the HU? Ive tried 100Hz on the HU, but that muddies up the mids too much.</p></blockquote><p></p>
[QUOTE="imsickofweed, post: 8646955, member: 668971"] Subs are D2 series parallel for 2ohm load at amp, my amp is not 1ohm stable. I set gains with my Fluke DMM at 30VAC with flat EQ, 0 bass boost and bas knob at 1/2 way. Subs are rated at 200wrms so Im not quite to 500wrms, but Im plenty more than 400wrms. Id say Im around 9/10 on the gain pot. I adjusted the bass boost to get a little more boomy rumble on some songs and now I like it on most songs. I turn it down on more of the mild bass/trance tracks, but it stays at 2-3 90% of the time. I have my low pass sub filter on the HU at 80Hz, but set it to 85 on the amp. Im guessing I should just set them the same or maybe go full range on the amp crossover and just set it with the HU? Ive tried 100Hz on the HU, but that muddies up the mids too much. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Twin Sundown SA6.5 SW D2 32Hz Ported 0.6ft3 in Ford Escape Box Build
Top
Menu
Home
Refresh