Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Twin Sundown SA6.5 SW D2 32Hz Ported 0.6ft3 in Ford Escape Box Build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="imsickofweed" data-source="post: 8644039" data-attributes="member: 668971"><p>Thank you for doing those graphs. Is it possible to see 0.6 and 0.7cuft at 40Hz?</p><p></p><p>I already finished most of the cabinet and I dont think I could move the baffle up high enough to make it 0.3 or 0.4cuft. It narrows towards the top so I run out of room for the driver before I get down to 0.3 or 0.4cuft. Also I was planning on my slot vent being 1”x8” which is 4cuin per driver. I think the 2” round port is too small so thats probably why the velocity is super high.</p></blockquote><p></p>
[QUOTE="imsickofweed, post: 8644039, member: 668971"] Thank you for doing those graphs. Is it possible to see 0.6 and 0.7cuft at 40Hz? I already finished most of the cabinet and I dont think I could move the baffle up high enough to make it 0.3 or 0.4cuft. It narrows towards the top so I run out of room for the driver before I get down to 0.3 or 0.4cuft. Also I was planning on my slot vent being 1”x8” which is 4cuin per driver. I think the 2” round port is too small so thats probably why the velocity is super high. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Twin Sundown SA6.5 SW D2 32Hz Ported 0.6ft3 in Ford Escape Box Build
Top
Menu
Home
Refresh