Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Tuning my system....where to start?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="neonblack" data-source="post: 7679834" data-attributes="member: 568995"><p>Adjust HPF and LPF on the amps with test tones. I would not set Low Pass above 60 Hz. (Subs are meant to play below 60 Hz. The low E on a guitar is 80 Hz so that gives you a reference point. You don't want that signal going thru your sub(s), you want it going thru your mids). The HPF and LPF have crossover slopes (see link) so the sub and mid signals will overlap somewhat as they descend and fade out. You have to use your ear and adjust crossovers to your liking. I set my Kenwood sub amp to 60 Hz and midrange amps to about 70 Hz and the filter signals both descend (at a certain rate) between the two frequencies and overlap so experiment til you get a balanced sound and the overall system loudness stays fairly constant thru that range.</p><p></p><p>All you need to know about amps are here:</p><p></p><p><a href="http://www.bcae1.com/" target="_blank">Basic Car Audio Electronics</a> (go to -&gt; 27. Crossover Slope Basics)</p></blockquote><p></p>
[QUOTE="neonblack, post: 7679834, member: 568995"] Adjust HPF and LPF on the amps with test tones. I would not set Low Pass above 60 Hz. (Subs are meant to play below 60 Hz. The low E on a guitar is 80 Hz so that gives you a reference point. You don't want that signal going thru your sub(s), you want it going thru your mids). The HPF and LPF have crossover slopes (see link) so the sub and mid signals will overlap somewhat as they descend and fade out. You have to use your ear and adjust crossovers to your liking. I set my Kenwood sub amp to 60 Hz and midrange amps to about 70 Hz and the filter signals both descend (at a certain rate) between the two frequencies and overlap so experiment til you get a balanced sound and the overall system loudness stays fairly constant thru that range. All you need to know about amps are here: [URL="http://www.bcae1.com/"]Basic Car Audio Electronics[/URL] (go to -> 27. Crossover Slope Basics) [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Tuning my system....where to start?
Top
Menu
What's new
Forum list