Reply to thread

Message: <blockquote data-quote="thch" data-source="post: 2222613" data-attributes="member: 562032">the explaination given -- that each channels sees 8/2 ohm (sub) in parallel with 4 ohm (component set), for an effective 2ohm load, is somewhat correct.  at least if you don't use a passive filter.the only real "gotcha" comes from the line of reasoning that components are a similar setup -- a 4ohm mid and a 4ohm tweeter in parallel.  but this gives a 4ohm load because of the filter.  since you are adding a filter on the components and the sub, there should be no frequencies where the impedance is less then 2ohm, assuming a 4ohm woofer and 2-4ohm speakers were used.</blockquote>

Top