Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
To everyone running audiopipe...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="tinmanchris217" data-source="post: 6259242" data-attributes="member: 610505"><p>No regrets yet. My stock 80 amp alt can't keep up at full tilt... (V = 11.5).</p><p></p><p>With a 1-1.1 ohm load, and impedance rise to 1.8-2.0 ohms, the amp burped 1125 w (45 V AC @ 25 amps), 3 seconds in... and there was very light distortion. Distortion ramped up soon after this point. This was 5 mins ago outside. //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif</p><p></p><p>They claim 1100 @ 2, and I can verify it, even at low volts.</p><p></p><p>My test procedures aren't spotless, but I did not use max hold, or any of the common mistakes. Just a Craftsman clamp meter and a separate multimeter, and a Canon digicam to make sure the measurement was at the same time.</p></blockquote><p></p>
[QUOTE="tinmanchris217, post: 6259242, member: 610505"] No regrets yet. My stock 80 amp alt can't keep up at full tilt... (V = 11.5). With a 1-1.1 ohm load, and impedance rise to 1.8-2.0 ohms, the amp burped 1125 w (45 V AC @ 25 amps), 3 seconds in... and there was very light distortion. Distortion ramped up soon after this point. This was 5 mins ago outside. [IMG]//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif[/IMG] They claim 1100 @ 2, and I can verify it, even at low volts. My test procedures aren't spotless, but I did not use max hold, or any of the common mistakes. Just a Craftsman clamp meter and a separate multimeter, and a Canon digicam to make sure the measurement was at the same time. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
To everyone running audiopipe...
Top
Menu
What's new
Forum list
