Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Tips or Advice on this Box design please.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Dragonsyph" data-source="post: 8662577" data-attributes="member: 675939"><p>Not sure on total weight but I know the MMS is like 510 grams. </p><p></p><p>Since in the port that back corner is wider, putting in a 45 to make it 6" wide in the corner to match the rest of the port, would that change the tuning? </p><p></p><p>As for rounding the port i think i just ment to flare the very end were it comes out like round them over a tad bit. Nothing like keifing etc. </p><p></p><p>Almost wanna start over and include all the braces and 45s for the corner and tune to 32hz, but then again ya lol. </p><p></p><p>A badass box tuned to 32 hz, might be what ill have to build. </p></blockquote><p></p>
[QUOTE="Dragonsyph, post: 8662577, member: 675939"] Not sure on total weight but I know the MMS is like 510 grams. Since in the port that back corner is wider, putting in a 45 to make it 6" wide in the corner to match the rest of the port, would that change the tuning? As for rounding the port i think i just ment to flare the very end were it comes out like round them over a tad bit. Nothing like keifing etc. Almost wanna start over and include all the braces and 45s for the corner and tune to 32hz, but then again ya lol. A badass box tuned to 32 hz, might be what ill have to build. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Tips or Advice on this Box design please.
Top
Menu
Home
Refresh