Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Off-topic Discussion
The Lounge
THE Thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="joshpoints" data-source="post: 178482" data-attributes="member: 546465"><p>I have blown three sets of subs in under two years. The first set the surrounds separated from the cone, looked like the glue gave out. The second time The wire that runs from the speaker terminal to the woofer burnt into two pieces and the surround came unglued. The third set the wire from the speaker terminal to the speaker cone gave out again. Is this manufacturing problems or is it my set-up? I have a kenwood 600 watt peak amp running bridged with the wires running + to - and - to +. The subs are jbl speakers and are rated at 250 watts rms each and peak at 1000 watts. THe first and second set, when I turned the speakers up loud the bass would cut out prior to the speaker damage. Help is greatly appreciated. THe sound of the subs is geat. I don't notice any distortion, except on low quality downloaded songs. I tried a lightning audio amp with the same ratings and the speakers didn't sound as good and had a tendency to distort. I tried a cheap amp rated at 1,000 watts and it sounded worse than the lightning audio amp.</p><p></p><p>What's the verdict?</p></blockquote><p></p>
[QUOTE="joshpoints, post: 178482, member: 546465"] I have blown three sets of subs in under two years. The first set the surrounds separated from the cone, looked like the glue gave out. The second time The wire that runs from the speaker terminal to the woofer burnt into two pieces and the surround came unglued. The third set the wire from the speaker terminal to the speaker cone gave out again. Is this manufacturing problems or is it my set-up? I have a kenwood 600 watt peak amp running bridged with the wires running + to - and - to +. The subs are jbl speakers and are rated at 250 watts rms each and peak at 1000 watts. THe first and second set, when I turned the speakers up loud the bass would cut out prior to the speaker damage. Help is greatly appreciated. THe sound of the subs is geat. I don't notice any distortion, except on low quality downloaded songs. I tried a lightning audio amp with the same ratings and the speakers didn't sound as good and had a tendency to distort. I tried a cheap amp rated at 1,000 watts and it sounded worse than the lightning audio amp. What's the verdict? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Off-topic Discussion
The Lounge
THE Thread
Top
Menu
What's new
Forum list