Reply to thread

Message: <blockquote data-quote="j3bus2k3" data-source="post: 2666613" data-attributes="member: 556020">Probably cause your not doing it right...heres how I do it:-At this point, you should have everything done, all 4 outside walls and port walls.-From the inside corner of one side, make a rectangle going across to the opposite corner effectivly making a top/plane-Draw your sub cutout with the circle tool, right clikc inside of it with the arrow, and hit erase-Now, with the push pull tool, raise your created top to your desired baffle height.-From there, you can either push/pull the other 4 walls to the same heigh, OR draw lines UPWARD (along the blue axis) to be equal with the top at all four corners and then connect...Hope thats clear...</blockquote>

Top