Reply to thread

Message

<blockquote data-quote="Fate710" data-source="post: 1352744" data-attributes="member: 557214">Well I&#039;m building a new system for the new car. The car is a &#039;90 CRX. It is being built as a show car. So far the car has some jank *** Pioneer CD player and I just bought today and installed Alpine 2-ways(Type-Ss). I&#039;m wanting to use all Alpine speakers because I get a good discount from the local dealer(small sponsorship you could say). I&#039;m fiberglassing almost the whole installation. Here is what will be going in.Doors: 2 Pair of Alpine SPS-171ARear Panel(Located on each side of the subwoofer space): Pair of Alpine SPS-170ATrunk Area: Alpine SPS-690A and SPS-130A(Going on the sides of the 20&quot; Flat Screen)Doors Amp: Crossfire VR602Rear Panel Amp: Crossfire VR202Trunk Area Amp: Crossfire VR402 for 6x9s and 5.25s(Should I get the bigger VR602?)Now on to the subwoofer setup.Subs: x2 Alpine SWS-1242DSub Amp: Crossfire BMF1000DI was just going to use an Alpine/Crossfire system. Should I drop the Jensen VM-9410 and just get an alpine source unit? Anything else you guys could think or if you think I should change the amps or you think of a better Alpine speaker(s) to go in the place of the ones I have chosen please let me know. I would like to start building this system soon as I will be collecting all of my materials to start my fiberglassing. Thanks!</blockquote>

[QUOTE="Fate710, post: 1352744, member: 557214"] Well I'm building a new system for the new car. The car is a '90 CRX. It is being built as a show car. So far the car has some jank *** Pioneer CD player and I just bought today and installed Alpine 2-ways(Type-Ss). I'm wanting to use all Alpine speakers because I get a good discount from the local dealer(small sponsorship you could say). I'm fiberglassing almost the whole installation. Here is what will be going in. Doors: 2 Pair of Alpine SPS-171A Rear Panel(Located on each side of the subwoofer space): Pair of Alpine SPS-170A Trunk Area: Alpine SPS-690A and SPS-130A(Going on the sides of the 20" Flat Screen) Doors Amp: Crossfire VR602 Rear Panel Amp: Crossfire VR202 Trunk Area Amp: Crossfire VR402 for 6x9s and 5.25s(Should I get the bigger VR602?) Now on to the subwoofer setup. Subs: x2 Alpine SWS-1242D Sub Amp: Crossfire BMF1000D I was just going to use an Alpine/Crossfire system. Should I drop the Jensen VM-9410 and just get an alpine source unit? Anything else you guys could think or if you think I should change the amps or you think of a better Alpine speaker(s) to go in the place of the ones I have chosen please let me know. I would like to start building this system soon as I will be collecting all of my materials to start my fiberglassing. Thanks! [/QUOTE]

Verification