Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Subwoofers
SX not loud enough..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="lilgator" data-source="post: 3086553" data-attributes="member: 559917"><p>Somebody posted a comment about the sx being a spl woofer and I stated its not. Tinsel slap is simple if its just one woofer I would just resolder all tinsel leads to the same length. I have a soldering iron, soldering heat gun, oscillioscope, and have done done amp repair, and computer motherboards for 9yrs, and a degree in mechanical engineering.</p><p></p><p>I wouldnt change the length of one tinsel unless i was going to change the length of all of them. If one lead is shorter, or longer then more current will flow to the shortest lead. This may not cause you a big problem if you dont, but it would be the proper way to do it</p></blockquote><p></p>
[QUOTE="lilgator, post: 3086553, member: 559917"] Somebody posted a comment about the sx being a spl woofer and I stated its not. Tinsel slap is simple if its just one woofer I would just resolder all tinsel leads to the same length. I have a soldering iron, soldering heat gun, oscillioscope, and have done done amp repair, and computer motherboards for 9yrs, and a degree in mechanical engineering. I wouldnt change the length of one tinsel unless i was going to change the length of all of them. If one lead is shorter, or longer then more current will flow to the shortest lead. This may not cause you a big problem if you dont, but it would be the proper way to do it [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Subwoofers
SX not loud enough..
Top
Menu
What's new
Forum list
