Reply to thread

Message: <blockquote data-quote="youdoofus" data-source="post: 8630364" data-attributes="member: 664079"><p>right. as long as the load is 1 ohm at the amp, then youre good. The worst thing that can happen (not counting shorting the +'s and -'s) would be a higher load at the amp resulting in less power. wire each sub down to 2and run the +'s to the +'s and the -'s to the -'s and youll be set. There are other ways of doing this with less wire, but youll be fine doing this.</p></blockquote><p></p>

Top