Reply to thread

Message

<blockquote data-quote="sundownz" data-source="post: 6831872" data-attributes="member: 549523">SPECIFICATIONS:D2RE: 3.927 ohmsFs: 43.59 HzQes: 0.643Qms: 4.404Qts: 0.555Le: 2.75 mHVas: 7.22 LBL: 13.023 NACms: 131 uM/NMms: 101 gramsSens: 81.53 1w/1mXmax: 10.5mm one-way linearPower: 200 RMSD4RE: 6.12 ohmsFs: 44.7 HzQes: 0.5456Qms: 3.6545Qts: 0.4748Le: 4.02 mHVas: 7.26 LBL: 17.45 NACms: 131 uM/NMms: 96 gramsSens: 82.59 1w/1mXmax: 10.5mm one-way linearPower: 200 RMS----Measured D4 specs finally. I manipulated the winding width a little so the D4 actually ended up with slightly higher motor force than the D2 -- good stuff //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif</blockquote>

[QUOTE="sundownz, post: 6831872, member: 549523"] [B]SPECIFICATIONS:[/B] [B]D2[/B] RE: 3.927 ohms Fs: 43.59 Hz Qes: 0.643 Qms: 4.404 Qts: 0.555 Le: 2.75 mH Vas: 7.22 L BL: 13.023 NA Cms: 131 uM/N Mms: 101 grams Sens: 81.53 1w/1m Xmax: 10.5mm one-way linear Power: 200 RMS [B]D4[/B] RE: 6.12 ohms Fs: 44.7 Hz Qes: 0.5456 Qms: 3.6545 Qts: 0.4748 Le: 4.02 mH Vas: 7.26 L BL: 17.45 NA Cms: 131 uM/N Mms: 96 grams Sens: 82.59 1w/1m Xmax: 10.5mm one-way linear Power: 200 RMS ---- Measured D4 specs finally. I manipulated the winding width a little so the D4 actually ended up with slightly higher motor force than the D2 -- good stuff [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] [/QUOTE]

Verification