Reply to thread

Message

<blockquote data-quote="shizzzon" data-source="post: 6825788" data-attributes="member: 590338">The way how you describe that test is it sounds like you did it with a subwoofer wired to the amp?If that&#039;s true then you sound ignorant stating the lower the frequency the less it outputted...I am assuming the box that was used was tuned below 70hz... so if this is true... then it would be typical to see a reduction of power output the lower you go in the frequency spectrum.&nbsp; The closer you get to tuning, the higher the impedance rise will be...I see no information on the rise value when you state the output power of the amp and i believe it is because you guys never measured it...Therefore... if that&#039;s true, then it wasn&#039;t worth mentioning what you mentioned.If i&#039;m wrong about my assumptions then speak up. I&#039;m just goin off what you didn&#039;t mentioned and filled in with typical setup techniques...</blockquote>

[QUOTE="shizzzon, post: 6825788, member: 590338"] The way how you describe that test is it sounds like you did it with a subwoofer wired to the amp? If that's true then you sound ignorant stating the lower the frequency the less it outputted... I am assuming the box that was used was tuned below 70hz... so if this is true... then it would be typical to see a reduction of power output the lower you go in the frequency spectrum. The closer you get to tuning, the higher the impedance rise will be... I see no information on the rise value when you state the output power of the amp and i believe it is because you guys never measured it... Therefore... if that's true, then it wasn't worth mentioning what you mentioned. If i'm wrong about my assumptions then speak up. I'm just goin off what you didn't mentioned and filled in with typical setup techniques... [/QUOTE]

Verification