Reply to thread

Message

<blockquote data-quote="misfit138" data-source="post: 6483221" data-attributes="member: 611275">4 awg power and ground wire will work just fine with the Hifonics 1610D.RMS Power Output: 1 x 550 W @ 4 OhmsRMS Power Output: 1 x 1100 W @ 2 OhmsRMS Power Output: 1 x 1600 W @ 1 OhmProtection: DC, Speaker Short, Thermal, OverloadPower Supply MOSFETAudio Output MOSFETDampening Factor: &amp;gt;250Signal To Noise Ratio (A-weighted): &amp;gt;95dBVariable Input Level Control (unbalanced): 0.2V - 9VInput Level Control (balanced): 0.04V - 18VInput Impedance (un-balanced): 47k-OhmInput Impedance (balanced): 20k-OhmPower / Diagnostic L.E.D.Variable Low Pass Filter / 24dB: 35Hz - 250HzVariable Subsonic Filter / 24dB: 15Hz - 35HzVariable Bass EQ: 0dB - +10dBPhase Shift (0 - +180 degrees)Unbalanced Inputs (RCA)Balanced Inputs (DIN)Line Output (RCA)Speaker Terminals (molded): 12gaPower/Ground Terminals (molded): 4gaRemote Bass Module: HFR-3Parametric bass EQ with 45Hz bass boost and variable control from 0db to 10dbVariable Low Pass, Subsonic Filter, Phase Shift and Level ControlBalanced line input for MX accessories and line driversBass Remote includedBuilt-In System Diagnostics protects from short circuits, over load, thermal overheat and DC Offset.Dimensions 14.17&quot; x 2.52&quot; x 9.45&quot;</blockquote>

[QUOTE="misfit138, post: 6483221, member: 611275"] 4 awg power and ground wire will work just fine with the Hifonics 1610D. RMS Power Output: 1 x 550 W @ 4 Ohms RMS Power Output: 1 x 1100 W @ 2 Ohms RMS Power Output: 1 x 1600 W @ 1 Ohm Protection: DC, Speaker Short, Thermal, Overload Power Supply MOSFET Audio Output MOSFET Dampening Factor: >250 Signal To Noise Ratio (A-weighted): >95dB Variable Input Level Control (unbalanced): 0.2V - 9V Input Level Control (balanced): 0.04V - 18V Input Impedance (un-balanced): 47k-Ohm Input Impedance (balanced): 20k-Ohm Power / Diagnostic L.E.D. Variable Low Pass Filter / 24dB: 35Hz - 250Hz Variable Subsonic Filter / 24dB: 15Hz - 35Hz Variable Bass EQ: 0dB - +10dB Phase Shift (0 - +180 degrees) Unbalanced Inputs (RCA) Balanced Inputs (DIN) Line Output (RCA) Speaker Terminals (molded): 12ga [B]Power/Ground Terminals (molded): 4ga[/B] Remote Bass Module: HFR-3 Parametric bass EQ with 45Hz bass boost and variable control from 0db to 10db Variable Low Pass, Subsonic Filter, Phase Shift and Level Control Balanced line input for MX accessories and line drivers Bass Remote included Built-In System Diagnostics protects from short circuits, over load, thermal overheat and DC Offset. Dimensions 14.17" x 2.52" x 9.45" [/QUOTE]

Verification