Reply to thread

Message

<blockquote data-quote="subzero" data-source="post: 6878429" data-attributes="member: 600350"><p>when you say&nbsp; that you have been messing around with changing the sound. I assume that you have been playing with the gain settings too.&nbsp;&nbsp; When I look at your setup I immediatly thing that your wires are to thin.&nbsp; You might need to slap 4 gauge on each amp and 0 gauge from battery to the fuse block and distroblock.&nbsp; &nbsp; Next you need to make sure you dont have that four channel clipping any drivers.&nbsp; You could turn the gain up and cut the high pass freq up, but then your pulling current away from the sub amp.&nbsp;&nbsp; I went through this with my system a few times till I got the settings down and increased the amperage draw capabilities by going with o gauge wire.&nbsp;&nbsp; Try this and keep in mind that the gain settings are to match the output of the deck.&nbsp; &nbsp; turning the gain up more will only lead to clipping at higher volumes which will seem to come alot fast when you shorten that spectrum. clip would start around 30?&nbsp; lets say you got&nbsp; a volume spectrum of 50. ok well&nbsp; turn it all the way up and turn the amps gains all the way down .&nbsp;&nbsp; then slowly turn up the amp gain till it starts to&nbsp; sound distorted then back of a bit till it has gone away. Then do the same for the sub...</p></blockquote><p></p>

[QUOTE="subzero, post: 6878429, member: 600350"] when you say that you have been messing around with changing the sound. I assume that you have been playing with the gain settings too. When I look at your setup I immediatly thing that your wires are to thin. You might need to slap 4 gauge on each amp and 0 gauge from battery to the fuse block and distroblock. Next you need to make sure you dont have that four channel clipping any drivers. You could turn the gain up and cut the high pass freq up, but then your pulling current away from the sub amp. I went through this with my system a few times till I got the settings down and increased the amperage draw capabilities by going with o gauge wire. Try this and keep in mind that the gain settings are to match the output of the deck. turning the gain up more will only lead to clipping at higher volumes which will seem to come alot fast when you shorten that spectrum. clip would start around 30? lets say you got a volume spectrum of 50. ok well turn it all the way up and turn the amps gains all the way down . then slowly turn up the amp gain till it starts to sound distorted then back of a bit till it has gone away. Then do the same for the sub... [/QUOTE]

Verification