Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Subs Sound Funny
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Preston019" data-source="post: 8082306" data-attributes="member: 644608"><p>Okay guys,</p><p></p><p>I fixed the screws on the subs (used t-nuts) and I made sure the box was air tight; that didn't work.</p><p></p><p>Next, I went and got an Audio Control LC2i, installed it, re-set the gain on my amp with an o-scope, and I'm still getting a sloppy bass.</p><p></p><p>I listened to the bass more carefully and noticed that the sloppy-sounding bass occurs at the higher bass frequencies when the volume is at about half-way. The low-pass filter is still set at ~100Hz, I've tried opening it up some more, but it still happens.</p><p></p><p>Could it just be distortion and I'm not actually setting the gains properly? Because if I have to turn the gain down, it already sounds somewhat quiet; I had a single 10" Kicker at 150 W RMS in a truck box, also had the fiber fill stuffing in it, and it was louder than these two subs I have now.</p><p></p><p>Could the box I have now be too small for these subs? Should I look into building my own custom box (I have a ton of space in my vehicle)? Should I just get a professional to tune my system?</p><p></p><p>I'm at a loss here, advice would be appreciated.</p></blockquote><p></p>
[QUOTE="Preston019, post: 8082306, member: 644608"] Okay guys, I fixed the screws on the subs (used t-nuts) and I made sure the box was air tight; that didn't work. Next, I went and got an Audio Control LC2i, installed it, re-set the gain on my amp with an o-scope, and I'm still getting a sloppy bass. I listened to the bass more carefully and noticed that the sloppy-sounding bass occurs at the higher bass frequencies when the volume is at about half-way. The low-pass filter is still set at ~100Hz, I've tried opening it up some more, but it still happens. Could it just be distortion and I'm not actually setting the gains properly? Because if I have to turn the gain down, it already sounds somewhat quiet; I had a single 10" Kicker at 150 W RMS in a truck box, also had the fiber fill stuffing in it, and it was louder than these two subs I have now. Could the box I have now be too small for these subs? Should I look into building my own custom box (I have a ton of space in my vehicle)? Should I just get a professional to tune my system? I'm at a loss here, advice would be appreciated. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Subs Sound Funny
Top
Menu
What's new
Forum list