Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Subwoofers
Sub took a dump
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="BleuGT" data-source="post: 5097526" data-attributes="member: 560592"><p>I was running a sealed RE SE10 with 600w. I set my gains with the volume at 30. The loudest I've had it is 25 (for less than 5 seconds) other than that its below 20. Today i noticed there was hardly any bass coming from the sub. It wasn't punchy like normal either.</p><p></p><p>I did however have the phase select on 180 which i didn't realize. Also, the input sensitivity switch was on 100mv-2v as opposed to 2v-8v. I have an avic d3 with 2.2v preouts. Could either of these setting hurt my sub?</p><p></p><p>(When setting the gains (34.6v) if i put the sensitivity on 2v-8v, i only hit 25v with the gains maxed out. But on 100mv-2v it would reach 34.6v at about 1/4 turn so i left it)</p><p></p><p>Is it time for a new sub? //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif</p></blockquote><p></p>
[QUOTE="BleuGT, post: 5097526, member: 560592"] I was running a sealed RE SE10 with 600w. I set my gains with the volume at 30. The loudest I've had it is 25 (for less than 5 seconds) other than that its below 20. Today i noticed there was hardly any bass coming from the sub. It wasn't punchy like normal either. I did however have the phase select on 180 which i didn't realize. Also, the input sensitivity switch was on 100mv-2v as opposed to 2v-8v. I have an avic d3 with 2.2v preouts. Could either of these setting hurt my sub? (When setting the gains (34.6v) if i put the sensitivity on 2v-8v, i only hit 25v with the gains maxed out. But on 100mv-2v it would reach 34.6v at about 1/4 turn so i left it) Is it time for a new sub? [IMG]//content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif[/IMG] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Subwoofers
Sub took a dump
Top
Menu
What's new
Forum list
