Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Speakers
Sub problem, wont work unless u push or tap it.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="calebkhill" data-source="post: 7979267" data-attributes="member: 647857"><p>Tried hooking up some 15"s I used to have, and noticed only one hits. Before I took them out of the jeep (motor blew up), base would get hard then soft. Never checked it out real good, thought it was the amp, but after today I noticed only one works.</p><p></p><p>As for the busted one, it wont hit uunless i push or tap it, itll hit for a few seconds then cut out. And while it is hitting its not real clean.</p><p></p><p>I already googled around and most I could find was that the tensils may be bad. I actually did take it out and npticed one tensil wire seems to have a bad spot, looks kind of burned or something. Think cutting and resoldering this are may fix it?</p><p></p><p>Could tere be any other sources to this problem?</p><p></p><p>There is no noise or tightness when I push the cone.</p><p></p><p>Also, itsa single voice coil 8ohm RF sub.</p></blockquote><p></p>
[QUOTE="calebkhill, post: 7979267, member: 647857"] Tried hooking up some 15"s I used to have, and noticed only one hits. Before I took them out of the jeep (motor blew up), base would get hard then soft. Never checked it out real good, thought it was the amp, but after today I noticed only one works. As for the busted one, it wont hit uunless i push or tap it, itll hit for a few seconds then cut out. And while it is hitting its not real clean. I already googled around and most I could find was that the tensils may be bad. I actually did take it out and npticed one tensil wire seems to have a bad spot, looks kind of burned or something. Think cutting and resoldering this are may fix it? Could tere be any other sources to this problem? There is no noise or tightness when I push the cone. Also, itsa single voice coil 8ohm RF sub. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Speakers
Sub problem, wont work unless u push or tap it.
Top
Menu
Home
Refresh