Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
sub and port placement
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Lschevelle" data-source="post: 7265836" data-attributes="member: 609561"><p>with the sub up and port back the subs will be right under the rear deck. i was going to put deaden the trunk lid if i go that route anyway only reason i changed from the sub back port up design is because i read that when bending aeros it cause port noise and two 8" would be best but its hard to find them and the three 6" wouldnt have enough port area</p></blockquote><p></p>
[QUOTE="Lschevelle, post: 7265836, member: 609561"] with the sub up and port back the subs will be right under the rear deck. i was going to put deaden the trunk lid if i go that route anyway only reason i changed from the sub back port up design is because i read that when bending aeros it cause port noise and two 8" would be best but its hard to find them and the three 6" wouldnt have enough port area [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
sub and port placement
Top
Menu
What's new
Forum list