Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Sub/Amp Help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="tommymilan311" data-source="post: 8407125" data-attributes="member: 664761"><p>It sounds fine. Crutchfield has the 800W at 1 ohm. I contacted Alpine about it, they said the same thing. I have wired to 1 ohm, I did the 9 hour drive 1 ohm, and have been there for, IDK, a month or two. The amp never gets hot or anything like that, even after hours of use. It sounds fine, but I feel like is isn't as loud as it could be. I know I'm not at RMS for the speakers. I don't have a clamp test, but I was getting 30-40V from the speaker wire at the amp. Which if at 1 ohm (I know it isn't consistently at 1 ohm) Im at 900w-1600w. So roughly 1500w, 750w a speaker</p></blockquote><p></p>
[QUOTE="tommymilan311, post: 8407125, member: 664761"] It sounds fine. Crutchfield has the 800W at 1 ohm. I contacted Alpine about it, they said the same thing. I have wired to 1 ohm, I did the 9 hour drive 1 ohm, and have been there for, IDK, a month or two. The amp never gets hot or anything like that, even after hours of use. It sounds fine, but I feel like is isn't as loud as it could be. I know I'm not at RMS for the speakers. I don't have a clamp test, but I was getting 30-40V from the speaker wire at the amp. Which if at 1 ohm (I know it isn't consistently at 1 ohm) Im at 900w-1600w. So roughly 1500w, 750w a speaker [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Sub/Amp Help
Top
Menu
What's new
Forum list