Reply to thread

Message

<blockquote data-quote="MakeshiftAudio" data-source="post: 6693111" data-attributes="member: 608963">Someone does not know what they&#039;re talking about. //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif I agree with them not being blow rated impedance, but then again if you don&#039;t need to go that low what&#039;s the point in bashing it? If they can do rated power at 1/2 ohm, and you can calculate box rise easily enough, there&#039;s not much magic to it.What do you have in regards to proof of it not being clean power? I mean, since it goes to 10khz it has to be good enough to drive mids. I think you&#039;re just a nobody that has not actually tested, nor knows how to test the &quot;cleanliness&quot; of a signal. Please stop regurgitating what you hear from the other people that do not have an idea of what they&#039;re talking about. These amps are also meant to drive woofers and midbass. That is how they&#039;re being used in many other places besides America/Most of Europe.The 1k5 has an adjustable sub sonic filter. The older ones that did not have a subsonic filter has a 6dB 20Hz subsonic filter. If you&#039;re good(*cough*like me*cough*) you can change that value with a little investigation.Now for the OP&#039;s question: I&#039;d go for the M3 personally if it&#039;s cheap enough.</blockquote>

[QUOTE="MakeshiftAudio, post: 6693111, member: 608963"] Someone does not know what they're talking about. [IMG]//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif[/IMG] I agree with them not being blow rated impedance, but then again if you don't need to go that low what's the point in bashing it? If they can do rated power at 1/2 ohm, and you can calculate box rise easily enough, there's not much magic to it. What do you have in regards to proof of it not being clean power? I mean, since it goes to 10khz it has to be good enough to drive mids. I think you're just a nobody that has not actually tested, nor knows how to test the "cleanliness" of a signal. Please stop regurgitating what you hear from the other people that do not have an idea of what they're talking about. These amps are also meant to drive woofers and midbass. That is how they're being used in many other places besides America/Most of Europe. The 1k5 has an adjustable sub sonic filter. The older ones that did not have a subsonic filter has a 6dB 20Hz subsonic filter. If you're good(*cough*like me*cough*) you can change that value with a little investigation. Now for the OP's question: I'd go for the M3 personally if it's cheap enough. [/QUOTE]

Verification