Reply to thread

Message

<blockquote data-quote="SPL140.2" data-source="post: 3055954" data-attributes="member: 559635">Im sure they do //content.invisioncic.com/y282845/emoticons/rolleyes.gif.c1fef805e9d1464d377451cd5bc18bfb.gif the amps are rated at 13.8 volts this rep isnt the same guy who is flooding stetsom on termpro is it??Channels: 1RMS Power @ 13.8VMono 1 Ohm: 7000 WattsMono 2 Ohms: 4500 WattsMono 4 Ohms: 2400 WattsRMS Power @ 12.6VMono 1 Ohm: 5200 WattsMono 2 Ohms: 4300 WattsMono 4 Ohms: 2100 WattsMinimal Input Impedance: 0,2VTotal Harmonic Distortion:Signal to Noise: &amp;gt; 90 dBCrossover Frequency LOW PASS: 50 a 15 KHzFrequency Response: (FULL RANGE) 20 Hz a 15 KHz (-3dB)Input Tension: 9 a 16VPower Consumption: 6 a 480 ADimensions: 70 x 280 x 660 mmweight: 10,0 Kg.</blockquote>

[QUOTE="SPL140.2, post: 3055954, member: 559635"] Im sure they do [IMG]//content.invisioncic.com/y282845/emoticons/rolleyes.gif.c1fef805e9d1464d377451cd5bc18bfb.gif[/IMG] the amps are rated at 13.8 volts this rep isnt the same guy who is flooding stetsom on termpro is it?? Channels: 1 RMS Power @ 13.8V Mono 1 Ohm: 7000 Watts Mono 2 Ohms: 4500 Watts Mono 4 Ohms: 2400 Watts RMS Power @ 12.6V Mono 1 Ohm: 5200 Watts Mono 2 Ohms: 4300 Watts Mono 4 Ohms: 2100 Watts Minimal Input Impedance: 0,2V Total Harmonic Distortion: Signal to Noise: > 90 dB Crossover Frequency LOW PASS: 50 a 15 KHz Frequency Response: (FULL RANGE) 20 Hz a 15 KHz (-3dB) Input Tension: 9 a 16V Power Consumption: 6 a 480 A Dimensions: 70 x 280 x 660 mm weight: 10,0 Kg. [/QUOTE]

Verification