Reply to thread

Message

<blockquote data-quote="rick1967" data-source="post: 8310979" data-attributes="member: 660035"><p>I am very new to this upgrading stereo business and I really dont know what I&#039;m doing. I have a 2014 Camry with the base system that I have added An Audio Control Lc6i,Rockford fosgate rx600 5 channel amp as well as Polk 6 1/2 components in the doors and polk 691 6x9&#039;s in the rear deck and a Kicker 10&quot; in a truck box. . I summed the channels inside the LC6i to get good clear signal to the back channels and I started tuning as per audio controls instructions with volume&nbsp; set to 3/4. The maximized lite on the LC6i started to blink at about 3/4 on the output control. I&#039;ve got a good clear full&nbsp; sound but I cant get much volume (It was plenty loud with no cutting off and on before I added the LC6i) without the system shutting on and off until I turn down the volume. What can cause this condition? Any advice would be greatly appreciated.RICK.</p></blockquote><p></p>

[QUOTE="rick1967, post: 8310979, member: 660035"] I am very new to this upgrading stereo business and I really dont know what I'm doing. I have a 2014 Camry with the base system that I have added An Audio Control Lc6i,Rockford fosgate rx600 5 channel amp as well as Polk 6 1/2 components in the doors and polk 691 6x9's in the rear deck and a Kicker 10" in a truck box. . I summed the channels inside the LC6i to get good clear signal to the back channels and I started tuning as per audio controls instructions with volume set to 3/4. The maximized lite on the LC6i started to blink at about 3/4 on the output control. I've got a good clear full sound but I cant get much volume (It was plenty loud with no cutting off and on before I added the LC6i) without the system shutting on and off until I turn down the volume. What can cause this condition? Any advice would be greatly appreciated.RICK. [/QUOTE]

Verification