Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
SS VGA 800.2 question...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="rideac1" data-source="post: 964125" data-attributes="member: 559603"><p>I just got my amp back from SoundStream from repair. When I first reinstalled it, the "RCA open" led was on, I figured it was bad, so I checked my connections and switched with the ATT switch. I remembered that before the led was not on. I looked it up in the manual and I guess it is supposed to be on. Does anyone else know if it IS supposed to be on.</p><p></p><p>Also I have an Alpine HU which its output voltage is 4v. The vga says to put the ATT switch to on if it is 4-12v, but is it bad for me to leave it on? It plays a little louder off than on, so I figure it would be less strain leaving the gain and boost down some.</p></blockquote><p></p>
[QUOTE="rideac1, post: 964125, member: 559603"] I just got my amp back from SoundStream from repair. When I first reinstalled it, the "RCA open" led was on, I figured it was bad, so I checked my connections and switched with the ATT switch. I remembered that before the led was not on. I looked it up in the manual and I guess it is supposed to be on. Does anyone else know if it IS supposed to be on. Also I have an Alpine HU which its output voltage is 4v. The vga says to put the ATT switch to on if it is 4-12v, but is it bad for me to leave it on? It plays a little louder off than on, so I figure it would be less strain leaving the gain and boost down some. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
SS VGA 800.2 question...
Top
Menu
What's new
Forum list
