Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
SPL vs Compact Build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="SimulatedZero" data-source="post: 8448416" data-attributes="member: 643373"><p>I did a whole lot of review reading and box modeling and I'm settling on two Sundown SA 12's for my system.</p><p></p><p>I'm looking at running them with the PPI BA5000.1 to run about 1.4 to 2k RMS to them in a ~2.9 ft^3 box (after port and driver displacement) tuned to somewhere around 29 to 31 hz. I haven't quite decided where I want the response curve to sit yet.</p><p></p><p>I have a stock alt and haven't done the big 3 plus I'm pulling another ~250w RMS for my mids and highs. What all should I do to handle that kind if power draw? Or would I be good, but right on the limit?</p></blockquote><p></p>
[QUOTE="SimulatedZero, post: 8448416, member: 643373"] I did a whole lot of review reading and box modeling and I'm settling on two Sundown SA 12's for my system. I'm looking at running them with the PPI BA5000.1 to run about 1.4 to 2k RMS to them in a ~2.9 ft^3 box (after port and driver displacement) tuned to somewhere around 29 to 31 hz. I haven't quite decided where I want the response curve to sit yet. I have a stock alt and haven't done the big 3 plus I'm pulling another ~250w RMS for my mids and highs. What all should I do to handle that kind if power draw? Or would I be good, but right on the limit? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
SPL vs Compact Build
Top
Menu
Home
Refresh