Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
SPL Trunk 'Wall' Build Log
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Buck" data-source="post: 8755714" data-attributes="member: 591582"><p>That is quite a different thing haha. It's all good though. Full power should ramp everything up a bit. You're obviously going to have tons of pressure around tuning. I think sealing it off will help the high end a bit, because that's where your vent speeds are going to be the lowest, generally. So, that pressure is lower and having it sealed would keep more pressure at the face of the box.</p><p></p><p>I hope I'm not being too redundant. Pressure works in stages, and you can really boost sub loading and port loading by changing what's around the box, to an extent.</p></blockquote><p></p>
[QUOTE="Buck, post: 8755714, member: 591582"] That is quite a different thing haha. It's all good though. Full power should ramp everything up a bit. You're obviously going to have tons of pressure around tuning. I think sealing it off will help the high end a bit, because that's where your vent speeds are going to be the lowest, generally. So, that pressure is lower and having it sealed would keep more pressure at the face of the box. I hope I'm not being too redundant. Pressure works in stages, and you can really boost sub loading and port loading by changing what's around the box, to an extent. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
SPL Trunk 'Wall' Build Log
Top
Menu
Home
Refresh