Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Builds
Car Audio Build Logs
SPL Trunk 'Wall' Build Log
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Jonnyswboy" data-source="post: 8755537" data-attributes="member: 677275"><p>Hooked it up to my buddies two MD8ks briefly (underpowered but wanted to get an idea of the response curve) and it moves a lot of air. Peaking at 30hz which is a little lower than I wanted, but I don't mind it. Starts dropping off sharply beyond ~37hz. I clamped one of the amps/subs and it was about 5.5ohms at 28hz, which as I understand would be 2.75 ohms once they're wired in parallel to 0.5ohm on my amp. 2.75ohm is not bad. Would like to be closer to 1.5ohms but I should be alright.</p><p></p><p>This is clamping ~1500w per speaker, so about half power. I will post a longer video on full power once my electrical is installed.</p><p></p><p>[ATTACH=full]30967[/ATTACH]</p></blockquote><p></p>
[QUOTE="Jonnyswboy, post: 8755537, member: 677275"] Hooked it up to my buddies two MD8ks briefly (underpowered but wanted to get an idea of the response curve) and it moves a lot of air. Peaking at 30hz which is a little lower than I wanted, but I don't mind it. Starts dropping off sharply beyond ~37hz. I clamped one of the amps/subs and it was about 5.5ohms at 28hz, which as I understand would be 2.75 ohms once they're wired in parallel to 0.5ohm on my amp. 2.75ohm is not bad. Would like to be closer to 1.5ohms but I should be alright. This is clamping ~1500w per speaker, so about half power. I will post a longer video on full power once my electrical is installed. [ATTACH type="full" align="left"]30967[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Builds
Car Audio Build Logs
SPL Trunk 'Wall' Build Log
Top
Menu
What's new
Forum list
