Reply to thread

Message: <blockquote data-quote="Chris02NeonSXT" data-source="post: 332509" data-attributes="member: 544477">I am all finished with my fiberglass enclosure, but I ran into a little problem when trying to install the subwoofer after I had carpeted the box.  The speaker ring is one that reccesses the sub, and come to find out, either from the way I cut it (with a jigsaw) or from sanding it, that down near the mounting piece, it is too small.  It seems like the walls of the reccess are angled outwards as you go from the mounting ring up towards where the fiberglass was laid over the ring.  My question is, is there any way I can make the walls of the reccess more square/flat?  Possibly with a router?  The reccess is about 3/4" to 1" deep.Thanks,Chris</blockquote>

Top