Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Speaker output voltage??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="herculeshero" data-source="post: 8310537" data-attributes="member: 648642"><p>So I've searched and searched on here trying to find this similar situation and I only found one with no answer that would help me. From what I've read and seen about setting amplifier gains you test the speaker outputs with a DMM according to ohms law with the wattage and resistance and all that. BUT when I test the speaker outputs i'm hardly getting 4 volts with my gain turned all the way up. I have a hifonics brutus 1200.1 with 4 gauge ground and power and when I wire my sub up(SA-10 dual 4ohm) it plays but not near as loud as I would expect with 900 watts going to it. I've tested the sub impedance and its wired correctly down to 2 ohms and the power going to the amp is good. Why am I seeing such little output?? Please help!</p></blockquote><p></p>
[QUOTE="herculeshero, post: 8310537, member: 648642"] So I've searched and searched on here trying to find this similar situation and I only found one with no answer that would help me. From what I've read and seen about setting amplifier gains you test the speaker outputs with a DMM according to ohms law with the wattage and resistance and all that. BUT when I test the speaker outputs i'm hardly getting 4 volts with my gain turned all the way up. I have a hifonics brutus 1200.1 with 4 gauge ground and power and when I wire my sub up(SA-10 dual 4ohm) it plays but not near as loud as I would expect with 900 watts going to it. I've tested the sub impedance and its wired correctly down to 2 ohms and the power going to the amp is good. Why am I seeing such little output?? Please help! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Speaker output voltage??
Top
Menu
Home
Refresh