Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Speaker and Amp Setup???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="MonteCarlo-Dice" data-source="post: 7660068" data-attributes="member: 639909"><p>I have a KenWood kdc - x891 head unit with three sets of preamp outputs (front, rear, sub).</p><p></p><p>I want to power these 6x9's with a concept cc-1252 amp</p><p></p><p>Concept Amp Specs:</p><p></p><p>RMS Power 125W x 2 4 Ohm</p><p></p><p>Signal-to-noise ratio: 100 dB</p><p></p><p>Frequency Response: 5Hz - 50kHz</p><p></p><p>18dB per octave crossover</p><p></p><p>Input sensitivity: 200mV - 4V</p><p></p><p>Im already powering my Memphis M3 subs with a Memphis 1000d.</p><p></p><p>My question is can I power my 3.5 speakers with the head unit as my front speakers and my 5.25 speakers with the head unit as my rear speakers and still use the rear pre amp output from my head unit to the concept amp to power my Polk db691's??? And will the concept amp blow my Polk db691's?</p></blockquote><p></p>
[QUOTE="MonteCarlo-Dice, post: 7660068, member: 639909"] I have a KenWood kdc - x891 head unit with three sets of preamp outputs (front, rear, sub). I want to power these 6x9's with a concept cc-1252 amp Concept Amp Specs: RMS Power 125W x 2 4 Ohm Signal-to-noise ratio: 100 dB Frequency Response: 5Hz - 50kHz 18dB per octave crossover Input sensitivity: 200mV - 4V Im already powering my Memphis M3 subs with a Memphis 1000d. My question is can I power my 3.5 speakers with the head unit as my front speakers and my 5.25 speakers with the head unit as my rear speakers and still use the rear pre amp output from my head unit to the concept amp to power my Polk db691's??? And will the concept amp blow my Polk db691's? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Speaker and Amp Setup???
Top
Menu
What's new
Forum list
