Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Subwoofers
SoundSplinter RL-P15 port diameter
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Lightninghoof" data-source="post: 2993509" data-attributes="member: 569919"><p>Woah, I think you may be doing something wrong in that case. When I plugged in the correct data I was getting port velocity results in the low teens.</p><p></p><p>Right click on the graph and make sure the units of measurement are set properly. You want it set to m/s and to be outputting "peak" velocity. (not "p-p" or "rms")</p><p></p><p>Also, make sure you are on the correct graph.</p><p></p><p>Make sure WinISD recognizes that you are calculating for 60 square inches (not centimeters) of port area.</p><p></p><p>Keep messing with it.</p></blockquote><p></p>
[QUOTE="Lightninghoof, post: 2993509, member: 569919"] Woah, I think you may be doing something wrong in that case. When I plugged in the correct data I was getting port velocity results in the low teens. Right click on the graph and make sure the units of measurement are set properly. You want it set to m/s and to be outputting "peak" velocity. (not "p-p" or "rms") Also, make sure you are on the correct graph. Make sure WinISD recognizes that you are calculating for 60 square inches (not centimeters) of port area. Keep messing with it. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Subwoofers
SoundSplinter RL-P15 port diameter
Top
Menu
What's new
Forum list
