Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Sound Distortion
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="dereche" data-source="post: 8658720" data-attributes="member: 675765"><p>I recently installed a set of Rockford Fostage speakers to the front and back doors in my '08 outback. I also installed a new receiver. The sound comes out of every speaker and it sounds fine, but when I try to kick it up to a higher volume it just sounds flat out terrible with heavy distortion, especially in tracks with a lot of bass. I'm wondering if this could possibly be the solder work on the wires for the receiver? I already resoldered the ones that even seemed loose, so I'm not sure it's that. Could it be the wire connection is loose from speakers? Or is it possible that my settings on my receiver are all jacked up. Before I tear the whole thing apart again, I wanted to get some opinions as to what is going on. </p></blockquote><p></p>
[QUOTE="dereche, post: 8658720, member: 675765"] I recently installed a set of Rockford Fostage speakers to the front and back doors in my '08 outback. I also installed a new receiver. The sound comes out of every speaker and it sounds fine, but when I try to kick it up to a higher volume it just sounds flat out terrible with heavy distortion, especially in tracks with a lot of bass. I'm wondering if this could possibly be the solder work on the wires for the receiver? I already resoldered the ones that even seemed loose, so I'm not sure it's that. Could it be the wire connection is loose from speakers? Or is it possible that my settings on my receiver are all jacked up. Before I tear the whole thing apart again, I wanted to get some opinions as to what is going on. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Sound Distortion
Top
Menu
Home
Refresh