Reply to thread

Message

<blockquote data-quote="joeldirt" data-source="post: 1711703" data-attributes="member: 558163"><p>Today while cutting some panels on the striebig for a curved receptionist desk, I suddenly came up with an idea... I am building two 3 ft3 boxes.. one at 30 hz... and one at 38 hz.&nbsp;&nbsp; They are both for a single Immortal 12... one is ASISD12 which was the old school Immortal Subs which imo are better&nbsp; the other is an AWIS12P which is the new chrome flamed out basket type....&nbsp; Any how&nbsp; I have designed the enclosures and am going to be cutting out the pieces on the striebig tomorow.... A striebig is a $25,000.00 panel saw which cuts both vertically and horizontaly on panels that are up to 7feet wide, and 15 ft long... This saw cuts within 1/1000th of a milimeter square.... Exactly exact..... So I began thinking about doing that as a service... Sending people perfectly perfect cut pieces of MDF from their own designs and specifications... No home depot guy who doesnt understand teh importance of true cuts to exact dimensions....&nbsp; I figure for people with out a table saw would apreciate that... Also could make circle cut outs for ports, or subs with the jasper circle jig...&nbsp; I think alot of people would use that service if it were for a reasonable price.&nbsp; I am just not sure if it would actually be worth it... Does it seem like a good idea or a waste of time?&nbsp; looking forward to feedback.</p></blockquote><p></p>

[QUOTE="joeldirt, post: 1711703, member: 558163"] Today while cutting some panels on the striebig for a curved receptionist desk, I suddenly came up with an idea... I am building two 3 ft3 boxes.. one at 30 hz... and one at 38 hz. They are both for a single Immortal 12... one is ASISD12 which was the old school Immortal Subs which imo are better the other is an AWIS12P which is the new chrome flamed out basket type.... Any how I have designed the enclosures and am going to be cutting out the pieces on the striebig tomorow.... A striebig is a $25,000.00 panel saw which cuts both vertically and horizontaly on panels that are up to 7feet wide, and 15 ft long... This saw cuts within 1/1000th of a milimeter square.... Exactly exact..... So I began thinking about doing that as a service... Sending people perfectly perfect cut pieces of MDF from their own designs and specifications... No home depot guy who doesnt understand teh importance of true cuts to exact dimensions.... I figure for people with out a table saw would apreciate that... Also could make circle cut outs for ports, or subs with the jasper circle jig... I think alot of people would use that service if it were for a reasonable price. I am just not sure if it would actually be worth it... Does it seem like a good idea or a waste of time? looking forward to feedback. [/QUOTE]

Verification