Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Slant face box - Cut angles
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="scoob8000" data-source="post: 5315089" data-attributes="member: 547804"><p>So I'm going to try my first slant face box with my new table saw.</p><p></p><p>9" tall</p><p></p><p>16" wide</p><p></p><p>20" deep-bottom</p><p></p><p>17" deep-top</p><p></p><p>The face of the box is going to sit at about a 20* angle.</p><p></p><p>On the front board, can I just cut each end at an opposite 20* angle?</p><p></p><p>OR</p><p></p><p>Cut one end at 70* and the mating board at 20*, bringing the angles together at a 90*?</p><p></p><p>The first option gives me a lot less to screw up. Box isn't going to be anything fancy, more so just a practice box for the heck of it. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif</p></blockquote><p></p>
[QUOTE="scoob8000, post: 5315089, member: 547804"] So I'm going to try my first slant face box with my new table saw. 9" tall 16" wide 20" deep-bottom 17" deep-top The face of the box is going to sit at about a 20* angle. On the front board, can I just cut each end at an opposite 20* angle? OR Cut one end at 70* and the mating board at 20*, bringing the angles together at a 90*? The first option gives me a lot less to screw up. Box isn't going to be anything fancy, more so just a practice box for the heck of it. [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Slant face box - Cut angles
Top
Menu
What's new
Forum list
